Skip to main content

1-661-295-1295

Preparing for Connectors


Step-by-Step Instructions

Step 1

Cut cable to the desired length.

Step 2

Mark a line on cable using a pen or marker.

Step 3

Cut the jacket along the line on both sides of the cable.

Step 4

Slice the jacket between wires along the dotted lines as shown.

Step 5

Strip the end of each wire using tweezers.

Step 6

Arrange ends of wires as shown to fit into the back shell. Terminate wire (solder or crimp).

Step 7

Additional sealing may be added to the interface between the wire and the backshell.

Step 8

Close clam shell and tighten hardware.